Wheels and Tires: 2D-16
6) If the distance between the rim line and wheel rim
varies, this indicates that the bead is not properly
seated. If this is the case, deflate the tire completely
and unseat the bead for both sides. Coat the bead
with lubricant and fit the tire again.
7) When the bead has been fitted properly, adjust the
pressure to specification.
8) As necessary, adjust the tire balance. Refer to
“Wheel Balance Check and Adjustment (Page 2D-
17)”.
Cold inflation tire pressure
9) Install the mounting drum to the rear wheel. (For rear
wheel) Refer to “Rear Wheel Dust Seal / Bearing
Removal and Installation (Page 2D-13)”.
10) Install the wheel assembly. Refer to “Front Wheel
Assembly Removal and Installation (GSF650/S/U/
SUK7) (Page 2D-4)” and “Rear Wheel Assembly
Removal and Installation (GSF650/S/U/SUK7)
(Page 2D-11)”.
Wheel / Tire / Air Valve Inspection and Cleaning
B817H22406012
Refer to “Tire Removal and Installation (Page 2D-15)”.
Wheel
Wipe the wheel clean and check for the following points:
• Distortion and crack
• Any flaws and scratches at the bead seating area.
• Wheel rim runout. Refer to “Front Wheel Assembly
Removal and Installation (GSF650/S/U/SUK7)
(Page 2D-4)” and “Rear Wheel Assembly Removal
and Installation (GSF650/S/U/SUK7) (Page 2D-11)”.
Tire
Tire must be checked for the following points:
• Nick and rupture on side wall
• Tire tread depth (Refer to “Tire Inspection in Section
0B (Page 0B-20)”.)
• Tread separation
• Abnormal, uneven wear on tread
• Surface damage on bead
• Localized tread wear due to skidding (Flat spot)
• Abnormal condition of inner liner
Air Valve
Inspect the air valve for peeling and damage. If any
defect is found, replace the air valve with a new one.
Refer to “Air Valve Removal and Installation (Page 2D-
17)”.
Inspect the valve core seal (1) for wear and damage. If
any defect is found, replace the valve core with a new
one. Refer to “Air Valve Removal and Installation
(Page 2D-17)”.
Front Rear
Solo riding
250 kPa
(2.50 kgf/cm
2
)
250 kPa
(2.50 kgf/cm
2
)
Dual riding
250 kPa
(2.50 kgf/cm
2
)
290 kPa
(2.90 kgf/cm
2
)
“B”
I649G1240040-02
I649G1240041-02
1. Seal
I649G1240042-02
I649G1240043-02
I649G1240044-02
1
I649G1240045-02
To Next Page
Loading...
Need help?
General
