3A-2 Drive Chain / Drive Train / Drive Shaft:
Engine Sprocket Removal and Installation
B817H23106002
Removal
1) Support the motorcycle with the center stand.
2) Remove the engine sprocket outer cover (1).
3) Remove the regulator/rectifier bracket (2).
4) Remove the gearshift link arm (3).
NOTE
Mark the marking to the matching surface of
gearshift link arm before removing.
5) Remove the speed sensor (4).
6) Remove the engine sprocket cover along with the
clutch release cylinder.
7) Remove the speed sensor rotor (5) by removing its
bolt while depressing the rear brake pedal.
8) Remove the engine sprocket nut (6) while
depressing the rear brake pedal.
1
I717H1310002-02
2
I717H1310003-03
3
I717H1310004-02
4
I717H1310005-03
5
I717H1310006-05
6
I717H1310007-01
To Next Page
Loading...
Need help?
General
