Brake Control System and Diagnosis: 4A-8
7) Loosen the air bleeder valve and pump the brake
pedal until the old brake fluid flows out of the brake
system.
8) Close the air bleeder valve and disconnect the clear
hose.
Tightening torque
Air bleeder valve (Rear brake) (a): 6 N·m (0.6
kgf-m, 4.5 lbf-ft)
9) Fill the reservoir with brake fluid to the upper mark
reservoir.
Brake Hose Removal and Installation
B817H24106009
Removal
1) Drain brake fluid. Refer to “Brake Fluid Replacement
(Page 4A-7)”.
2) Remove the front and rear brake hoses as shown in
the front and rear brake hose routing diagram. Refer
to “Front Brake Hose Routing Diagram (GSF650)
(Page 4A-1)” or “Front Brake Hose Routing Diagram
(GSF650S) (Page 4A-2)” and “Rear Brake Hose
Routing Diagram (Page 4A-3)”.
Installation
CAUTION
!
The seal washers should be replaced with the
new ones to prevent fluid leakage.
1) Install the front and rear brake hoses as shown in the
front and rear brake hose routing diagram. Refer to
“Front Brake Hose Routing Diagram (GSF650)
(Page 4A-1)” or “Front Brake Hose Routing Diagram
(GSF650S) (Page 4A-2)” and “Rear Brake Hose
Routing Diagram (Page 4A-3)”.
2) Bleed air from the front and rear brake system. Refer
to “Air Bleeding from Brake Fluid Circuit (Page 4A-
5)”.
I717H1410015-01
I717H1410009-01
I717H1410010-01
To Next Page
Loading...
Need help?
General
