8-10 COOLING AND LUBRICATION SYSTEM
If the resistance is noted to show infinity or too much different
resistance value, replace the ECT sensor with a new one.
#
INSTALLATION
• Install the new sealing washer 1.
• Tighten the ECT sensor 2 to the specified torque.
$ ECT sensor: 18 N·m (1.8 kgf-m, 13.0 lb-ft)
#
• Install the rear intake pipe and thermostat assembly.
(!3-112)
• Install the air cleaner chamber and throttle body. (!6-21)
• Pour engine coolant. (!2-21)
* Take special care when handling the ECT sensor. It
may cause damage if it gets a sharp impact.
* Do not contact the ECT sensor and the column ther-
mometer with a pan.
* Replace the removed sealing washer 1 with a new
one.
* Take special care when handling the ECT sensor. It
may cause damage if it gets a sharp impact.
To Next Page
Loading...
Need help?
General
