9-26 CHASSIS
• Inspect handlebar bushings for damage.
• If any damage is found, replace the handlebar bushing with a
new one.
REASSEMBLY
Reassemble the steering stem in the reverse order of disassem-
bly. Pay attention to the following points:
OUTER RACE
• Press in the upper and lower bearing outer races with the
special tools.
% 09941-34513: Steering outer race installer set
INNER RACE
• Press in the lower bearing with the special tool.
% 09925-18011: Steering bearing installer
INSTALLATION
Install the steering stem in the reverse order of removal. Pay
attention to the following points:
BEARING
• Apply SUZUKI SUPER GREASE “A” to the bearings.
' 99000-25010: SUZUKI SUPER GREASE “A”
or equivalent
• Install the upper bearing 1 to the steering stem.
STEERING STEM NUT
• Install the dust seal 1.
• Install the steering stem 2.
• Install the steering stem nut 3 as shown.
NOTE:
The flange side A of the steering stem must face lower.