PERIODIC MAINTENANCE 2-19
FINAL GEAR OIL
• Keep the motorcycle upright.
• Place an oil pan under the final gear case.
• Remove the filler cap 1 and drain plug 2 to drain oil.
• Tighten the drain plug 2 to the specified torque. Pour the
specified oil (SAE 90 hypoid gear oil with GL-5 under API
classification) through the filler hole until the oil level reaches
the filler hole.
• Refit the filler cap 1.
# Final gear oil drain plug: 23 N·m (2.3 kgf-m, 16.5 Ib-ft)
% Final gear oil: 200 – 220 ml
(6.8/7.0 – 7.4/7.7 US/Imp oz)
THROTTLE CABLE PLAY
Adjust the throttle cable play A as follows.
• Loosen the lock nut 2 of the throttle pulling cable 1.
• Turn the adjuster 3 in or out until the throttle cable play (at
the throttle grip) A is between 2.0 – 4.0 mm (0.08 – 0.16 in).
• Tighten the lock nut 2 while holding the adjuster 3.
% Throttle cable play A: 2.0 – 4.0 mm (0.08 – 0.16 in)
'
PAIR (AIR SUPPLY) SYSTEM
Inspect the PAIR (air supply) system periodically. ($12-6)
Replace initially at 1 000 km (600 miles, 2 months) and
inspect every 12 000 km (7 500 miles, 24 months)
thereafter.
Inspect initially at 1 000 km (600 miles, 2 months) and
every 6 000 km (4 000 miles, 12 months) thereafter.
After the adjustment is completed, check that handle-
bar movement does not raise the engine idle speed
and that the throttle grip returns smoothly and auto-
matically.
Inspect every 12 000 km (7 500 miles, 24 months).
To Next Page
Loading...
Need help?
General
