Suzuki VZR1800 2007 User Manual

2-18 PERIODIC MAINTENANCE
OIL FILTER REPLACEMENT
• Drain the engine oil as described in the engine oil replace-
ment procedure.
• Remove the oil filter 1 with the special tool.
& 09915-40610: Oil filter wrench
• Apply engine oil lightly to the gasket of the new oil filter before
installation.
• Install the new oil filter. Turn it by hand until you feel that the
oil filter gasket contacts the oil filter mounting surface. Then,
tighten the oil filter two full turns with the special tool.
NOTE:
To properly tighten the oil filter, use the special tool. Never
tighten the oil filter by hand.
# Oil filter: 20 N·m (2.0 kgf-m, 14.5 lb-ft)
• Add new engine oil and check the oil level is as described in
the engine oil replacement procedure.
% NECESSARY AMOUNT OF ENGINE OIL:
Oil change : 3.4 L (3.6/3.0 US/Imp qt)
Oil and filter change : 3.6 L (3.8/3.2 US/Imp qt)
Engine overhaul : 4.7 L (5.0/4.1 US/Imp qt)
"
After contacting the
gasket, tighten 2 turns.
(20 N·m, 2.0 kgf-m, 14.5 lb-ft)
ONLY USE A GENUINE SUZUKI MOTORCYCLE OIL
FILTER. Other manufacturer’s oil filters may differ in
thread specifications (thread diameter and pitch), fil-
tering performance and durability which may lead to
engine damage or oil leaks. Also, do not use a genuine
Suzuki automobile oil filter on this motorcycle.

Suzuki VZR1800 2007 Specifications

General

Displacement	1783 cc
Bore x Stroke	112.0 mm x 90.5 mm
Compression Ratio	10.5:1
Fuel System	Fuel injection
Ignition	Electronic ignition (transistorized)
Final Drive	Shaft drive
Front Suspension	Inverted telescopic, coil spring, oil damped
Rear Suspension	Link type, coil spring, oil damped
Front Brakes	Dual hydraulic disc
Rear Brakes	Single hydraulic disc
Engine Type	4-stroke, liquid-cooled, DOHC, 54-degree V-twin
Transmission	5-speed
Front Tire	130/70R18M/C 63H
Overall Height	1185 mm
Seat Height	705 mm
Torque	160 Nm @ 3200 rpm
Ground Clearance	140mm
Overall Length	2485 mm (97.8 in)
Power	125 hp (93 kW) @ 6200 rpm