10-40 ELECTRICAL SYSTEM
HEADLIGHT RELAY INSPECTION
headlight relay is located in front of the battery.
• Remove the right frame side cover. (!9-5)
• Remove the headlight relay 1.
First check the insulation between A and B terminals with
tester. Then apply 12 volts to C and D terminals, + to C and
- to D, and check the continuity between A and B.
If there is no continuity, replace it with a new one.
" 09900-25008: Multi-circuit tester set
- Tester knob indication: Continuity test (.)
HEADLIGHT BEAM ADJUSTMENT
• Adjust the headlight beam.
NOTE:
To adjust the headlight beam, adjust the beam horizontally first,
then adjust vertically.
A: Horizontal adjuster
B: Vertical adjuster
To Next Page
Loading...
Need help?
General
