3-25
OPERATION
GETTING OUT OF MUD
If the machine gets stuck in mud, use the
procedure below to get it out.
If tires on one side are stuck
OPERATING PROCEDURES
1. Slew the bucket to the side of the tires
being stuck.
2. Set the arm and boom to an angle of 90
to 110°.
3. Press the bottom of the bucket (not the
teeth) against the ground to raise the
stuck tires.
4. Place a plank or the like under the raised
tires.
5. Lift the bucket and slowly move the
machine out of the mud.
If tires on both sides are stuck
1. Perform the steps 1 to 4 above for both
tires.
2. Dig the bucket into the ground in front of
the machine.
3. Pull the arm while traveling forward to
slowly move the machine out.
To Next Page
Loading...
Need help?
General
