2-12
CONTROLS
SEAT AND SEAT BELT
SEAT AND SEAT BELT
AIR SUSPENSION SEAT
• Adjust and secure the seat.
• Do not make any adjustments while
operating the machine.
• Do not set the backrest to its maximum
reclining position and slide the seat
backwards at the same time. Doing so
may damage the rear window or cause
injury.
• Remember that the backrest returns to
the forward position abruptly due to the
spring force.
(A) Adjusting the lumber support
1. Turning the knob (1) in the direction of the
arrow causes the lumber of the backrest
to curve outwards.
2. Turning the knob (1) further removes the
curve and returns the seat to its original
position.
(B) Adjusting the backrest angle
1. Sit up and sit back in the chair.
2. Pull up the lever (2), adjust the backrest
rear angle by using the spring force on the
chair back. Release the lever (2) at the
desired angle to secure the backrest.
(C) Adjusting the absorber
The seat adjustment using the absorber is
applicable for various traveling conditions on
roads or off roads. The cushioning effect can
be individually set for each case.
Turn the lever (3) to the desired position and
release.
Positions between
1: Soft cushioning
and
4: Hard cushioning
To Next Page
Loading...
Need help?
General
