5-18
MAINTENANCE
INSPECTING THE WATER SEPARATOR
AND THE FUEL FILTERS
Warning
•Donotsmokeorpermitopenames
while handling fuel or working on the
fuel system.
•Stoptheengineinawell-ventilated
place and allow it to cool down before
performing maintenance.
•Cleanupspilledfuelimmediately.
Water separator
DAILY INSPECTION (EVERY 10 HOURS)
1. Turn the starter switch to the ON position.
2. Inspect the water separator warning lamp.
3. If the warning lamp is flashing, drain the
water.
Refer to “Draining the water from the
water separator” on page 5-63.
Fuel filters <TB290>
1.
Open the fuel lid or the side cover.
2. Check if there is water in the pre-fuel filter
(1) and the main fuel filter (2).
If water collects in the filter, the float (red
ring) (3) goes up. Be sure to drain water
before the float (3) goes up to the element
(4).
3.Loosetheventplug(5)andthenthedrain
plug (6) to discharge water collected
inside.
4. After drainage of water, tighten each plug
and bleed air from the fuel system.
Refer to “Bleeding air from the fuel
system” on page 6-8.