2-28
CONTROLS
WIPER SWITCH
IMPORTANT: If no washer fluid is
discharged, do not operate the washer.
Doing so may damage the pump.
IMPORTANT: Operating the wiper with no
moisture on the windshield will scratch
the glass. Use water or washer fluid when
operating the wiper.
IMPORTANT: In cold climates, the wiper
blade may freeze to the glass. Operating
the wiper forcibly may damage the wiper
motor.
SWITCHES
OFF ....Off
INT .....Intermittence operation
ON .....Continuous operation
WASHER SWITCH
ON .....Pressing the ON side of the switch
causes the washer to spray washer
fluid. To stop spraying, release the
switch.
AUTOMATIC DECELERATION SWITCH
When the ON side of the switch is pressed,
the deceleration lamp in the instrument
cluster flashes. This flashing stops when the
deceleration function starts working, and the
lamp remains lit while in the deceleration
mode. The engine speed automatically drops
to low idle (deceleration mode) four seconds
after the control levers are set to neutral, to
reduce fuel consumption. Moving the control
levers will cause the speed to return to the
original engine speed.
It is not possible to use the deceleration
button at the same time. The auto-
deceleration switch has priority over the
deceleration button. Switching from the
deceleration button to the auto-deceleration
switch will first return to the engine speed set
with the throttle controller. Then, the engine
will automatically enter the deceleration
mode (low idling) if the control levers are not
operated within four seconds.
This automatic deceleration function is
canceled when the starter switch is turned to
the OFF position.
To Next Page
Loading...
Need help?
General
