1-8
SAFETY
PRECAUTIONS WHEN
PREPARING
Know the work area
Before starting operation, know the working
area condition to ensure a safety operation.
•Inspectthetopographyandground
condition of the working area, or the
structure of the building when working
indoors, and take the safety precautions as
necessary.
•Besuretoavoidallhazardsand
obstructions such as ditches, underground
lines, trees, cliffs, overhead electrical wires,
or places where there is a danger of falling
rocks or slides.
PRECAUTIONS WHEN PREPARING
•Checkwiththeadministratorforthe
locations of buried gas pipes, water pipes
and power cables. If necessary, determine
what specific precautions must be taken to
insure safety by consulting with the
administrator.
•Whenworkingonroads,besureto
consider the safety of pedestrians and
vehicles.
· Use a flag person and/or a signal.
· Fence off the working area and keep off
unauthorized persons.
•Whenworkinginwaterorcrossingshallow
streams or creeks, check the depth of the
water, the solidity of the ground and the
water flow speed beforehand.
Refer to “Cautions on operating” for further
instructions.
Check the strength of the bridge
When traveling over a bridge or a structure,
check the permissible load. If the strength is
insufficient, reinforce the bridge or the
structure.
Always keep the machine clean
•Cleanwindows,mirrorsandlightsto
ensure good visibility.
Adjustthemirrortothebestpositionfor
the operator to see the rear view (blind
spot) from the operator’s seat.
•Wipeoffanyoil,grease,mud,snoworice,
to prevent accidents due to slipping.
•Removealllooseobjectsandunnecessary
devices from the machine.
•Removeanydirt,oilorgreasefromthe
engine area to prevent fires.
•Clean
aroundtheoperator’sseatand
removeanyunnecessaryobjectfromthe
machine.