5-22
MAINTENANCE
AFTER THE INITIAL 50
HOURS (ONLY FOR NEW
MACHINES)
REPLACING THE ENGINE OIL AND THE
OIL FILTER
Warning
Stop the engine and allow the machine to
cool down before performing
maintenance.
•Theengine,mufer,radiator,hydraulic
lines, sliding parts and many other parts
of the machine are hot immediately after
the engine is stopped. Touching these
parts will cause burns.
•Theengineoilisalsohot.
Be careful not to touch the hydraulic oil
when loosening the cap or plug.
Working on the machine under these
conditions could result in burns or
injuries.
Engine oil
<TB285>
AFTER THE INITIAL 50 HOURS (ONLY FOR NEW MACHINES)
<TB290>
1.
Open the engine hood and remove the oil
filler cap (2).
2.Loosen
theboltsandremovetheunder
cover (3).
3. Place a pan for catching the waste oil
under the drain plug (4).
4. Remove the cap (A), install connector (B)
and drain the oil. (The oil comes out when
the screw is tightened.)
5. Remove the connector (B) and install the
cap (A).
IMPORTANT: Check the waste oil for
metal powder. If it contains large amounts
of metal powder, consult your sales or
service dealer.
To Next Page
Loading...
Need help?
General
