Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
Examples
CH2:LABel:FON
T:UNDERline ON
sets the font to underlined.
CH2:LABel:FONT:UNDERline? might return : CH2:LABEL:FONT:UNDERLINE
0
indicating t
he font is not underlined.
CH<x>:LABel:NAMe
This command sets or queries the label attached to the displayed waveform for
the specifie
d channel. The channel is specified by x.
Group
Vertical
Syntax
CH<x>:LABel:NAMe <QString>
CH<x>:LABel:NAMe?
Arguments
<QString> is an alphanumeric character string, ranging from 1 through 32
characters in length.
Examples
CH2:LABEL:NAME "Pressure" changes the waveform label for the Channel 2
waveform to “Pressure”.
CH3:LABEL:NAME? might return :CH3:LABEL:NAME "Force", indicating that
the waveform label for the Channel 3 waveform is “Force”.
CH<x>:LABel:XPOS
This command sets or queries the X-position of the specified channel label. The
channel is specified by x.
Group
Vertical
Syntax
CH<x>:LABel:XPOS <NR3>
CH<x>:LABel:XPOS?
Arguments
<NR3> is the location (in pixels) where the waveform label for the selected
channel is displayed, relative to the left edge of the screen.
Examples
CH3:LABEL:XPOS 5 moves the waveform label for Channel 3 so that it begins
5 pixels to the right of the left edge of the screen.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-193

Tektronix MSO54 Specifications

General

Analog Channels	4
Sample Rate	6.25 GS/s
Vertical Resolution	12-bit
Form Factor	Benchtop
Probe Interface	TekVPI
Operating Temperature	0 °C to +50 °C
Bandwidth	1 GHz
Record Length	62.5 Mpoints
Display	15.6 inch HD
Waveform Update Rate	>500, 000 wfms/s
Trigger Types	Edge, Pulse, Runt, Logic, Serial
Serial Bus Support	I2C, SPI, RS-232/422/485/UART, CAN/CAN FD/LIN, USB 2.0, Ethernet
Connectivity	USB, Ethernet
Input Impedance	1 MΩ
Power Requirements	100-240 VAC, 50/60 Hz
Maximum Input Voltage	400 V (DC + peak AC)