Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
SEARCH:SEARCH
1:TRIGger:A:WINdow:CROSSIng?
might return
:SEARCH:SEARCH1:TRIGGER:A: WINDOW:CROSSING UPPER indicating that
CROSSING is set to UPPER.
SEARCH:SEAR
CH<x>:TRIGger:A:WINdow:LOGICQUALification
This command specifies or queries whether or not to u se logic qualification for a
window search. The search number is specified by <x>.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :WINdow:LOGICQUALification
{ON|OFF}
SEARCH:SEARCH<x>:TRIGger:A :WINdow:LOGICQUALification?
Arguments
ON specifies to use logic qualification for a w indow search.
OFF specifies not to us logic qualification for a window search.
Examples
SEARCH:SEARCH1:TRIGger:A:W INdow:LOGICQUALification ON turns ON
logic qualification for a window search.
SEARCH:SEARCH1:TRIGger:A:W INdow:LOGICQUALification? might
return
:SEARCH:SEARCH1:TRIGGER:A:W INDOW:LOGICQUALIFICATION OFF
indicating logic qualification is off.
SEARCH:SEARCH<x>:TRIGger:A:WINdow:POLarity
This command sets or queries the window trigger threshold crossing of the
selected trigger Source. The search number is specified by <x>.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :WINdow:POLarity
{UPPer|LOWer|EITher|NONe}
SEARCH:SEARCH<x>:TRIGger:A :WINdow:POLarity?
Arguments
UPPer specifies that the instrument triggers when the signal remains above the
upper threshold for longer than the time limit and then crosses downward through
the upper threshold.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-747

Tektronix MSO54 Specifications

General

Brand	Tektronix
Model	MSO54
Category	Test Equipment
Language	English