Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
Arguments
ONE filters stat
us words to only match those where the BUSY b it has a value of 1.
ZERo filters status words to only match those where the BUSY bit has a value of 0.
NOCARE disables filtering of status words on the BUSY bit.
Examples
SEARCH:SEARCH1:TRIGGER:A:B US:MIL1553B:STATUS:BIT:BUSY ONE
specifies filtering status words for those where the BUSY bit has a value of 1.
SEARCH:SEARCH1:TRIGGER:A:B US:MIL1553B:STATUS:BIT:BUSY? might
return NOCARE, indicating that status words are not being filtered based on the
BUSY bit value.
SEARCH:SEARCH<x>:TRIGger:A:BUS:MIL1553B:STATus:BIT:DBCA
This command sets or queries the value of the dynamic bus control acceptance bit
(DBCA bit, bit 18) in a status word for a MIL-STD-1553 bus to search on. The
search number is specified by x. The search condition must be set to STATus.
Conditions
Requires the SR-AERO Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:MIL1553B:STATus:BIT:DBCA {ONE
ZERo NOCARE}
SEARCH:SEARCH<x>:TRIGger:A :BUS:MIL1553B:STATus:BIT:DBCA?
Arguments
ONE filters status words to only match those where the DBCA bit has a value of 1.
ZERo filters status words to only match those where the DBCA bit has a value of 0.
NOCARE disables filtering of status words on the DBCA bit.
Examples
SEARCH:SEARCH1:TRIGGER:A:B US:MIL1553B:STATUS:BIT:DBCA ONE
specifies filtering status words for those where the DBCA bit has a value of 1.
SEARCH:SEARCH1:TRIGGER:A:B US:MIL1553B:STATUS:BIT:DBCA? might
return NOCARE, indicating that status words are not being filtered based on the
DBCA bit value.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-691

Tektronix MSO54 Specifications

General

Brand	Tektronix
Model	MSO54
Category	Test Equipment
Language	English