To Next Page

To Previous Page

Commands listed in alphabetical order

Arguments

FORWard speciﬁ

es a forward search to the edge.

BACKWard speciﬁ es a backward search to the edge.

Examples

MEASUrement:MEAS1:TOEDGES EARCHDIRect FORWARD speciﬁes a forward

search to the edge.

MEASUrement:MEAS1:TOEDGES EARCHDIRect? might return

:MEASUREMENT:MEAS1:TOEDGE SEARCHDIRECT FORWARD indicating the

instrument will search in the forward direction for the to edge.

MEASUrement:MEAS<x>:TRANSition

This command sets or queries the transition edges ﬂag for the meas urement. The

measurement number is speciﬁed by x.

Group

Measurement

Syntax

MEASUrement:MEAS<x>:TRANS ition {<NR1>|OFF|ON}

Arguments

<NR1> = 1, the measurement is computed on rising (if measurement type is

rise time) or falling edges (if measurement type is fall time) following a double

transition only. If it is set to 0 , the measurement is computed on all rising (if

measurement type is rise time) or falling (if measurement type is fall time) edges.

OFF compute s the measurement on all rising (if measurement type is rise time)

or falling (if measurement type is fall time) edges.

ON computes the measurement on rising (if measurement type is rise time) or

falling edges (if measurement type is fall time) following a double transition only.

Examples

MEASUrement:MEAS1:TRANSit ion 1 specifyingthe measurement is computed

on rising (if measurement type is rise time) or falling edges (if measurement type

is fall time) following a double transition only.

MEASUrement:MEAS1:TRANSit ion? might return

:MEASUREMENT:MEAS1:TRANSI TION 0 indicating the measurement is

computed on all rising (if measurement type is rise time) or falling (if

measurement type is fall time) edges.

MEASUrement:MEAS<x>:TYPe

This command sets or queries the measurement type. The measurement number

is speciﬁed by x.

2-488 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO54 Programmer's Manual

Other manuals for Tektronix MSO54