Commands listed in alphabetical order
MEASUrement:
MEAS<x>:EDGES:TOLevel
This command sets or queries the 'to level' edge for the measurement.
Measurements are specified by x.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:EDGES :TOLevel {HIGH|MID|LOW}
MEASUrement:MEAS<x>:EDGES :TOLevel?
Arguments
HIGH specifies the H IGH level.
MID specifies the MID level.
LOW specifies the LOW level.
Examples
MEASUrement:MEAS1:EDGES:T OLevel HIGH specifies the High to level.
MEASUrement:MEAS1:EDGES:T OLevel? might return
:MEASUREMENT:MEAS1:EDGES: TOLEVEL LOW indicating the to level
edge is set to the Low level.
MEASUrement:MEAS<x>:EDGES:UPPERFREQuency
This command sets o r queries the upper frequency for the measurement when the
measurement type is phase noise. Higher frequencies are ignored. Measurements
are specified by x.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:EDGES :UPPERFREQuency <NR3>
MEASUrement:MEAS<x>:EDGES :UPPERFREQuency?
Arguments
<NR3> is the upper frequency of the edge.
Examples
MEASUrement:MEAS1:EDGES:U PPERFREQuency 1.5 sets the upper frequency
to 1.5 MHz.
MEASUrement:MEAS1:EDGES:U PPERFREQuency? might return
:MEASUREMENT:MEAS1:EDGES: UPPERFREQUENCY 1.0000E+6 indicating the
upper frequency is 1.0 MHz.
2-446 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
