To Next Page

To Previous Page

Commands listed in alphabetical order

Syntax

MEASUrement:M

EAS<x>:CLOCKRecovery:MEANAUT OCalculate

{FIRST|EVERY}

MEASUrement:MEAS<x>:CLOCKR ecovery:MEANAUTOCalculate?

Arguments

FIRST calculates the clock on the ﬁrst acquisition.

EVERY calculates the clock on every acquisition.

Examples

MEASUrement:MEAS1:CLOCKRec overy:MEANAUTOCalculate E VERY causes

the clock to be calculated on every acquisition.

MEASUrement:MEAS1:CLOCKRec overy:MEANAUTOCalculate? might return

:MEASUREMENT:MEAS1:CLOCKRE COVERY:MEANAUTOCALCULATE FIRST

indicating the clock is calculated on the ﬁrst acquisition.

MEASUrement:MEAS<x>:CLOCKRecovery:METHod

This command sets or queries the clock recovery method for the measurement.

Measurements are speciﬁed by x.

Group

Measurement

Syntax

MEASUrement:MEAS<x>:CLOCKR ecovery:METHod

{PLL|CONSTANTCLOCK|EXPLICI TCLOCK}

MEASUrement:MEAS<x>:CLOCKR ecovery:METHod?

Arguments

PLL speciﬁes a phase locked loop clock recovery method.

CONSTANTCLOCK speciﬁes using a constant clock.

EXPLICITCLOCK speciﬁes using an explicit clock.

Examples

MEASUrement:MEAS1:CLOCKRec overy:METHod PLL speciﬁes a phase locked

loop clock recovery method.

MEASUrement:MEAS1:CLOCKRec overy:METHod? might return

:MEASUREMENT:MEAS1:CLOCKRE COVERY:METHOD CONSTANTCLOCK

indicating a constant clock is in u se.

MEASUrement:MEAS<x>:CLOCKRecovery:MODel

This command s ets or que ries the PLL clock recovery model used w h en PLL

clock recovery is used for the measurement. Measureme nts are speciﬁed by x.

MSO54, MSO56, MSO58, MSO58LP Programmer 2-437

Tektronix MSO54 Programmer's Manual

Other manuals for Tektronix MSO54