Multi Pro 1750 Page 3 − 21 Kohler Gasoline Engine
5. Install clutch cable to bracket on clutch housing
(Fig. 13). Set bulkhead nuts so an equal amount of ca-
ble housing thread appears on each side of the cable
bracket and tighten bulkhead nuts. Install ball joint to
throwout lever with lock nut and tighten. Install return
spring. Adjust clutch cable (see Clutch Cable Adjust-
ment in this chapter).
6. Install transaxle drive shaft to engine (see Transaxle
Drive Shaft in Chapter 7 − Drive Train in this manual).
7. Route wires away from moving and hot components
and connect the following engine electrical connections:
A. Connect engine wire harness to machine wire
harness (near starter).
B. Connect the blue starter signal wire to the starter
solenoid.
C. Install the fusible link and positive (+) battery
cable ring terminals to the starter solenoid (stud).
D. Connect battery negative (−) cable and machine
wire harness ground to engine base (Fig. 11).
E. Connect wire harness connector at spray pump
electric clutch.
8. Connect fuel line to the fuel pump on engine. Con-
nect evaporative system vapor hose to engine intake
manifold (left side of engine).
9. Install exhaust system (see Exhaust System in this
chapter).
10.Install choke cable to engine (Figs. 12). Check choke
cable adjustment (see Adjust Choke Cable in this chap-
ter).
11.Reconnect accelerator cable to engine (Figs. 12).
A. Fit accelerator cable to the engine speed control
bracket.
B. Slide the sleeve back on the cable ball joint and
place cable ball joint on ball stud. Release the sleeve
so it slides over the stud to secure cable.
C. Tighten cable jam nuts that secure accelerator
cable to control bracket.
12.Check engine oil level and transaxle/hydraulic fluid
level (see Operator’s Manual).
13.Connect positive (+) and then negative (−) battery
cables to the battery.
14.Check engine speed (see Adjust Engine Speed in
the Adjustments Section of this chapter).
Kohler
Gasoline Engine
To Next Page
Loading...
Need help?
General
