Multi Pro 1750Hydraulic System Page 4 − 20
6. Install fittings finger tight and far enough to make
sure that they are not cross−threaded before tightening
them with a wrench.
7. Position hydraulic tester hoses to prevent moving
machine parts from contacting and damaging the hoses
or tester.
8. Check fluid level in the hydraulic reservoir/transaxle.
After connecting test equipment, make sure reservoir/
transaxle is full.
9. Check control linkages for improper adjustment,
binding, or broken parts.
10.All hydraulic tests should be made with the hydraulic
fluid at normal operating temperature.
To Next Page
Loading...
Need help?
General
