H9 ASD Installation and Operation Manual 199
Panel Torque Command
Program Special Operation Panel Parameters
This function is not used with the H9 ASD.
The Torque Command selection is performed at F420.
Direct Access Number — F725
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — -250.00
Maximum — +250.00
Panel Tension Torque Bias
Program Special Operation Panel Parameters
This function is not used with the H9 ASD.
The Tension Torque Bias selection is performed at F423.
Direct Access Number — F727
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — -250.00
Maximum — +250.00
Units — %
Panel Load Sharing Gain
Program Special Operation Panel Parameters
This function is not used with the H9 ASD.
The Load Sharing Gain selection is performed at F424.
Direct Access Number — F728
Parameter Type — Numerical
Factory Default — 100.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 250.00
Units — %
Panel Override Multiplication Gain
Program Special Operation Panel Parameters
This parameter provides a value to be used in the event that Setting (F729) is
selected for the Frequency Override Multiplying Input (F661).
Direct Access Number — F729
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — -100.00
Maximum — 100.00
Units — %
Panel Frequency Lock Out
Program Special Operation Panel Parameters
This parameter is model-specific and has no function on the H9 ASD system.
Settings:
0 — Unlocked
1 — Locked
Direct Access Number — F730
Parameter Type — Selection List
Factory Default — Unlocked
Changeable During Run — Yes
Panel Emergency Off Lock Out
Program Special Operation Panel Parameters
This parameter is model-specific and has no function on the H9 ASD system.
Settings:
0 — Unlocked
1 — Locked
Direct Access Number — F734
Parameter Type — Selection List
Factory Default — Unlocked
Changeable During Run — No
F725 F734
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net