70 H9 ASD Installation and Operation Manual
System Operation
Initial Setup
Upon initial system power up, the Startup Wizard starts automatically. The Startup Wizard assists the
user with the initial configuration of the input power settings and the output parameters of the H9 ASD.
The Startup Wizard may also be selected and run from the Program menu after the initial startup, if
required.
The Startup Wizard querys the user to select one of the following items:
Run Now? Continue on to item 1 below.
Run Next Time? Go to Program Mode.
Manually Configure? Go to Finish screen and click Finish.
Startup Wizard Parameters
Startup parameter settings may be viewed or changed. Change the parameter setting and click Next. Or
click Next without making any changes to go to the next startup parameter.
See the section titled Startup Wizard Parameter Requirements on pg. 71 for further information on the
Startup Wizard parameters.
Click Finish to close the Startup Wizard when finished.
1. The Voltage and Frequency Rating of the Motor (Must make a selection to continue or click Finish).
2. The Upper-Limit Frequency.
3. The Lower-Limit Frequency.
4. The Automatic Acceleration/Deceleration Setting.
5. The Acceleration Time.
6. The Deceleration Time.
7. The Volts per Hertz Setting.
8. The Motor Current Rating.
9. The Motor RPM.
10. The Command Source.
11. The Frequency Reference Source.
12. The Display Unit.
13. Wizard: Finish.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
To Next Page
Loading...
Need help?
General
