H9 ASD Installation and Operation Manual 33
EOI Remote Mounting
The H9 ASD may be controlled from a remotely-mounted EOI. For safety and application-specific
reasons, some ASD installations will warrant that the operator not be in the vicinity during operation or
that the EOI not be attached to the ASD housing. Remote mounting will also allow for multiple EOI
mountings at one location if controlling and monitoring several ASDs from a central location is required.
The door-mounted EOI of the 230-volt 30-HP and above ASDs and the 460-volt 40 HP and above ASDs
use the remote mounting kit 58333 to allow for the door-mount EOI configuration.
The ease of installation and mounting distance away from the ASD may be increased with the use of the
optional remote mounting kit ASD-MTG-KIT9.
An EOI extender cable is required for remote mounting. The EOI extender cable is available in a 10-ft.
length and may be ordered through your TIC Sales Representative. Remote mounting may be extended up
to the distance supported by standard RS485 communication — typically 4000 feet (1200 meters)
maximum.
The optional dust cover (P/N ASD-BPC) may be used to cover the EOI opening of the ASD housing after
removing the EOI.
Remote EOI Hardware
EOI Mounting Hardware
• EOI Remote-Mount Housing — P/N 58333 (included with the 230-volt 30-HP and above; and with
the 460-volt 40 HP and above)
• 6-32 x 5/16” Pan Head Screw — P/N 50595 (4 ea.)
• #6 Split-Lock Washer — P/N 01884 (4 ea.)
• #6 Flat Washer — P/N 01885 (4 ea.)
Bezel Plate Mounting Hardware
• Bezel Plate — P/N 52291
• 10-32 Hex Nut — P/N 01922 (4 ea.)
• #10 Split-Lock Washer — P/N 01923 (4 ea.)
• #10 Flat Washer — P/N 01924 (4 ea.)
• Dust Cover — P/N ASD-BPC (Optional)
Extender Cable
• ASD-CAB10F: Cable, 10 ft.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
To Next Page
Loading...
Need help?
General
