Triumph 1050 Sprint User Manual

109
Maintenance and Adjustment
Position Lamp Bulb Replacement
The position lamps are fitted within the
headlight aperture.
Carefully remove the rubber bulb holder
from the back of the position lamp and
detach the bulb.
Installation is the reverse of the removal
procedure.
Rear Light
The rear light unit is a sealed, maintenance
free LED unit.
Warning
The bulbs become hot during use. Always
allow sufficient time for the bulbs to cool
before handling. Avoid touching the glass
part of the bulb. If the glass is touched or
gets dirty, clean with alcohol before re-use.
Caution
Ensure that the bulb holder is correctly
fitted to prevent water ingress.
Warning
When reconnecting the battery, connect
the positive (red) lead first.
Warning
Do not reconnect the battery until the
assembly process has been completed.
Premature battery reconnection could
result in ignition of the battery gases
causing risk of injury.
Warning
Riding the motorcycle with defective brake
lights is illegal and dangerous. In the event
of failure of the LED unit, consult your
authorised Triumph dealer.
An accident causing injury to the rider and
other road users may result from use of a
motorcycle with defective brake lights.

Triumph 1050 Sprint Specifications

General

Engine Type	Liquid-cooled, 12 valve, DOHC, in-line 3-cylinder
Displacement	1050 cc
Bore x Stroke	79 x 71.4 mm
Compression Ratio	12.0:1
Fuel System	Multipoint sequential electronic fuel injection
Final Drive	X ring chain
Clutch	Wet, multi-plate
Gearbox	6-speed
Front Brakes	Twin 320mm floating discs, 4 piston calipers
Rear Brakes	Single 255mm disc, 2 piston caliper
Front Tire	120/70 ZR17
Rear Tire	180/55 ZR17
Dry Weight	210 kg
Exhaust	Stainless steel 3 into 1 exhaust system
Ignition	Digital - inductive type
Frame	Aluminum beam perimeter
Front Suspension	43mm
Rear Suspension	Monoshock with adjustable preload
Rake/Trail	24 degrees
Dimensions	Length: 2, 115 mm, Width: 760 mm, Height: 1, 210 mm