Triumph 1050 Sprint User Manual

116
Storage
Preparation after Storage
Install the battery (if removed) (see
page 10 2 ).
If the motorcycle has been stored for more
than four months, change the engine oil (see
page 73).
Check all the points listed in the Daily Safety
Checks section.
Before starting the engine, remove the spark
plugs from each cylinder.
Put the side stand down.
Crank the engine on the starter motor several
times until the oil pressure light goes out.
Replace the spark plugs, tightening to
12 N m , and start the engine.
Check and if necessary correct the tyre
pressures (see page 12 0 ).
Check the brakes for correct operation.
Test ride the motorcycle at low speeds.

Triumph 1050 Sprint Specifications

General

Engine Type	Liquid-cooled, 12 valve, DOHC, in-line 3-cylinder
Displacement	1050 cc
Bore x Stroke	79 x 71.4 mm
Compression Ratio	12.0:1
Fuel System	Multipoint sequential electronic fuel injection
Final Drive	X ring chain
Clutch	Wet, multi-plate
Gearbox	6-speed
Front Brakes	Twin 320mm floating discs, 4 piston calipers
Rear Brakes	Single 255mm disc, 2 piston caliper
Front Tire	120/70 ZR17
Rear Tire	180/55 ZR17
Dry Weight	210 kg
Exhaust	Stainless steel 3 into 1 exhaust system
Ignition	Digital - inductive type
Frame	Aluminum beam perimeter
Front Suspension	43mm
Rear Suspension	Monoshock with adjustable preload
Rake/Trail	24 degrees
Dimensions	Length: 2, 115 mm, Width: 760 mm, Height: 1, 210 mm