Triumph 1050 Sprint User Manual

111
Maintenance and Adjustment
Licence Plate Light
Bulb Replacement
Carefully remove the rubber bulb holder
from the back of the licence plate light unit
and remove the bulb.
Installation is the reverse of the removal
procedure.
Windscreen Cleaning
Clean the windscreen with a solution of mild
soap or detergent and lukewarm water. After
cleaning, rinse well and then dry with a soft,
lint free cloth.
If the transparency of the windscreen is
reduced by scratches or oxidation which
cannot be removed, the windscreen must be
replaced.
Caution
To avoid cable damage, do not pull the
bulb holder using the cables.
Caution
Ensure that the bulb holder is correctly
fitted to prevent water ingress.
Caution
Products such as window cleaning fluids,
insect remover, rain repellent, scouring
compounds, petrol or strong solvents such
as alcohol, acetone, carbon tetrachloride,
etc. will damage the windscreen. Never
allow these products to contact the
windscreen.

Triumph 1050 Sprint Specifications

General

Engine Type	Liquid-cooled, 12 valve, DOHC, in-line 3-cylinder
Displacement	1050 cc
Bore x Stroke	79 x 71.4 mm
Compression Ratio	12.0:1
Fuel System	Multipoint sequential electronic fuel injection
Final Drive	X ring chain
Clutch	Wet, multi-plate
Gearbox	6-speed
Front Brakes	Twin 320mm floating discs, 4 piston calipers
Rear Brakes	Single 255mm disc, 2 piston caliper
Front Tire	120/70 ZR17
Rear Tire	180/55 ZR17
Dry Weight	210 kg
Exhaust	Stainless steel 3 into 1 exhaust system
Ignition	Digital - inductive type
Frame	Aluminum beam perimeter
Front Suspension	43mm
Rear Suspension	Monoshock with adjustable preload
Rake/Trail	24 degrees
Dimensions	Length: 2, 115 mm, Width: 760 mm, Height: 1, 210 mm