BA 50Z3/6003 en – Edition 4.3 * 5003b210.fm 2-13
Safety instructions
• If an energized line is touched nevertheless:
• Do not leave the machine.
• Drive the machine out of the risk zone.
• Warn others against approaching and touching the machine.
• Have the live wire de-energized.
• The user must not touch any metallic parts.
• Do not leave the machine until the line that has been touched or damaged has been
safely de-energized.
Gas, dust, steam, smoke
• Operate the machine only on adequately ventilated premises. Before starting internal
combustion engines or operating fuel-operated heating systems on enclosed premises,
ensure that there is sufficient ventilation.
Observe the regulations in force at the respective site.
• Welding, burning and grinding work on the machine may only be performed by a
Wacker Neuson dealer.
• In areas with special hazards (toxic gases, caustic vapours, toxic environments, for
example), wear appropriate protective equipment (breathing filters, protective clothing).
Hydraulic system
• Work on the hydraulic equipment of the machine must be performed only by persons
having specific technical knowledge and experience in hydraulic systems.
• Check all lines, hoses and threaded fittings regularly for leaks and visible damage.
Repair any damage and leaks immediately. Splashed oil can cause injury and fire.
• In accordance with the Operator’s Manual/instructions for the respective assembly,
release the pressure in all system sections and pressure lines (hydraulic system) to be
opened before performing any implementing/repair work.
• Hydraulic and compressed-air lines must be laid and fitted properly. Ensure that no
connections are interchanged. The fittings, lengths and quality of the hoses must
comply with the technical requirements.
Noise
• During operation all sound baffles must be closed.
• Wear ear protectors if necessary.
Oil, grease and other chemical substances
• When handling oil, grease and other chemical substances (battery electrolyte –
sulphuric acid, for example), observe the product-related safety regulations (safety data
sheet).
• Be careful when handling hot consumables – risk of burning or scalding.
• When using the machine in contaminated areas, take appropriate measures for the
protection of the driver and the machine.
Using the quickhitches in water
• Apply grease to the lubrication points before using the Easy Lock offset bucket in water.
• After using the quickhitch in water, apply grease to the lubrication points to remove all
water.
• Using the quickhitch in salt water is prohibited.
To Next Page
Loading...
Need help?
General
