Wacker Neuson 50Z3 User Manual

BA 50Z3/6003 en – Edition 4.3 * 5003b210.fm 2-15
Safety instructions
Working with a hammer
Caution!
Bear in mind the following for hammer operation:
☞ Keep the hammer perpendicular to the surface (max. deviation to all sides
is 2°).
☞ After you have driven the hammer into the material, do not try to fragment
the material with movements to the sides.
☞ Never move the hammer as you drive it into the material.
☞ Do not operate the hammer in the same spot uninterruptedly for more than
15 seconds.
☞ If the applied impact force does not break the material, move the hammer
to the edge or start again in another place in order to break the material.
☞ Do not put the hammer into operation if a ram is fully extended or retracted.
☞ Never use the hammer horizontally or upward.
☞ Do not use the hammer for catching or collecting material.
☞ Press the hammer firmly against the material to avoid hammer operation
without any resistance.
☞ Do not use the hammer to raise loads.
☞ Do not hit the hammer against rocks, concrete, etc..
☞ Do not raise the machine with the boom.
☞ Do not perform any movements with the machine during hammer operation.
☞ Working with the rams and/or the boom fully extended is not allowed.
☞ Do not swivel the Powertilt unit beyond 30° during hammer operation, oth-
erwise the load on the boom increases enormously.
2.16 Transport and towing
Towing
• Tow away only in accordance with the Operator’s Manual.
• For towing the machine observe the prescribed transport position, admissible speed
and itinerary.
Transport
• Load and transport only in accordance with the Operator’s Manual.
• Use only suitable means of transport of adequate capacity/payload.
• Use suitable mounting points and load-securing devices.
• Safely secure the machine on means of transport.
• In the event of an accident or evasive manoeuvre, the machine must not be able to
move either laterally, forward, backward or upward.
• The recommissioning procedure must be strictly in accordance with the Operator’s
Manual.
2° 2°
Fig. 52: Hammer position

Wacker Neuson 50Z3 Specifications

General

Brand	Wacker Neuson
Model	50Z3
Category	Excavators
Language	English