Xerox 2515 User Manual

5.1 Document Handler RAP
This RAP is used for document handler
faults that do not indicate
a status code.
One problem
is that the document is not
sensed
by the Document Handler.
Q
The circuit diagram is on the
next page.
Initial Actions
Ensure that the document is in
good condition.
Ensure that the Document
Handler
is properly grounded
(PL 5.1).
Refer to Normal Call for Anti
Static cleaning procedures.
Procedure
Enter the code [Top Right Segment] to
check the Front document sensor.
NOTE: The bottom Copy Output lamp
(2510) or the right Copy Media
lamp
(251 5) is lit on the Control
Panel when the sensor
is
blocked.
Actuate the Front Document Sensor
(Q1). The Copy Output lamp (2510) or
the right Copy Media lamp
(2515) goes
on then off when the sensor is actuated.
Go to FLAG
1 and check the wiring
for a short circuit.
If there is no short
circuit to frame, replace the Front
Document Sensor
(Q1). If the
problem persists replace the
Controller
PWB (A3).
Proceed to wrap up the call.
/ CONTROL PWB
I
CONTROL PWB
5.9 Document Handb* PRP

Xerox 2515 Specifications

General

Brand	Xerox
Model	2515
Category	Copier
Language	English