7. Select an operation mode from the Active Mode type: PServer Mode for Directory
and Bindery
8. Type the name of your primary file servers for the printer in the File Server field.
Note
Set this item only when the operation mode is in Bindery Service.
9. Type 1-100 in the Number of Searches.
Type 0 for no limit.
10. Select Enabled to enable the TBCP Filter.
Note
The TBCP Filter checkbox will have a checkmark in it indicating that the TBCP Filter
is enabled.
11. Type a name for the NDS tree in the NDS Tree field.
The default entry for this field is Xerox_DS_Tree. If you are using Bindery mode, leave
this field blank.
12. Type a context in the NDS Context field.
The default entry for this field is Xerox_DS_Context. If you are using Bindery mode,
leave this field blank.
Note
Set this item only when the operation mode is in Directory Service.
13. For the Service Location Protocol, select Enabled to enable SLP - Active Discovery.
14. Select Enabled next to Use SLP for Name Resolution.
15. Type the scope name in the Scope field.
16. Type the SLP server address in the SLP Server field.
17. Select Apply.
TCP/IP
Transmission Control Protocol (TCP) and Internet Protocol (IP) are two protocols within
the Internet Protocol Suite. IP manages the transmission of messages from computer
to computer while TCP manages the actual end-to-end connections. This section describes
the how to configure settings for TCP/IP.
You can configure IPv4 settings at the printer control panel or through CentreWare IS.
You can only configure IPv6 through CentreWare IS. By default, TCP/IP is enabled. It
must be enabled at the printer control before you can access CentreWare.
IPv6 is optional and may be used in addition to or in place of IPv4. IPv6 hosts can
automatically configure themselves when connected to a routed IPv6 network using
the Internet Control Message Protocol Version 6 (ICMPv6). ICMPv6 performs error
reporting for IP along with other diagnostic functions. When first connected to a network,
a host sends a link-local multicast router solicitation request for its configuration
parameters. Routers respond to this request with a router advertisement packet
containing network-layer configuration parameters.
1. Perform the following to access the network protocol settings.
Xerox
®
Color C75 Press3-6
System Administration Guide
Using CentreWare Internet Services
To Next Page
Need help?
General
