Configuration of Store to USB
This section describes how to configure the machine to use the Store to USB feature.
To use this feature, the optional USB Enablement Kit must be installed on the machine.
USB Memory Devices
The Store to USB feature allows you to directly save the scanned data to a USB 2.0
memory device that is inserted into the USB memory slot on the machine. The following
memory devices can be used:
• USB 2.0 memory devices
• USB memory devices with the capacity of up to 128 GB
• USB memory devices that support FAT12, FAT16, FAT32, or VFAT
Note
USB memory devices that are encrypted with software cannot be used with the
machine.
Enabling Store to USB
1. Log in as an administrator.
The default user ID is admin. When a passcode is required, the default passcode is
1111.
2. Press the Machine Status button.
3. Select the Tools tab.
4. Select Connectivity and Network Setup.
5. Select Port Settings.
6. Select USB.
7. Select Change Settings.
8. Select Port Status.
9. Select Enabled and then select Save.
10. Log out as the administrator and select Reboot Now.
11. When the machine reboots, log in again as the administrator.
12. Select Enter.
13. Repeat steps 2 - 5. then select Print Mode, PJL, Auto Eject Time, or Adobe
Communication Protocol to change any of these settings.
14. When you finish changing any of these settings, select Change Settings, and then
select Save.
15. Log out as the administrator.
7-13Xerox
®
Color C75 Press
System Administration Guide
Using the Scan Service
To Next Page
Loading...
Need help?
General
