Xerox Phaser 6120 Service Manual

Error Codes and Messages Index
Phaser® 6120 Color Laser Printer Service Manual
4-12
Error Codes and Messages Index
For the exact control panel fatal error message, see on page 3-9.
Code Description Detection Timing
04 Mechanical Control Board
malfunction
Communications with the M/C expansion IO G/A (IC on the
Mechanical Control Board) are not properly carried out.
05 Flash ROM malfunction Firmware upgrading has failed.
08 Main Motor malfunction The Motor Lock signal remains HIGH for a predetermined
consecutive period of time while the Main Motor remains
energized.
The Motor Lock signal remains LOW for a predetermined
consecutive period of time while the Main Motor remains
de-energized.
0B Transfer Fan Motor malfunction The Fan Motor Lock signal remains HIGH for a
predetermined consecutive period of time while the
Ventilation Fan Motor remains energized.
0C Power Supply Cooling Fan
Motor malfunction
The Fan Motor Lock signal remains HIGH for a
predetermined consecutive period of time while the Power
Supply Cooling Fan Motor remains energized.
0F Duplex Cooling Fan Motor
malfunction
The Fan Motor Lock signal remains HIGH for a
predetermined consecutive period of time while the Power
Supply Cooling Fan Motor remains energized.
For details, see the Duplex Unit Service Manual.
10 Laser Unit, Polygon Motor
malfunction
A LOW Motor Lock signal is not detected even after the
lapse of a predetermined period of time after the Polygon
Motor has been started.
The Motor Lock signal remains HIGH for a predetermined
consecutive period of time while the Polygon Motor
remains energized.
12 Laser Unit malfunction The SOS signal is not detected within a predetermined
period of time after the output of a laser has been started.
The SOS signal is never detected in the image area.
14 Transfer Roller, 2nd image
transfer pressure/retraction
failure
The state of the Retraction Position Sensor/2nd Image
Transfer is not changed from the unblocked to blocked
state even after the lapse of a predetermined period of time
during predrive.
The Retraction Position Sensor/2nd Image Transfer is in
the unblocked state even after the lapse of a
predetermined period of time during predrive.
The Retraction Position Sensor/2nd Image Transfer is not
blocked (roller in the retracted position) within a
predetermined period of time after the retraction sequence
of the 2nd Transfer Roller has been started.
The Retraction Position Sensor/2nd Image Transfer is not
unblocked (roller in the pressed position) within a
predetermined period of time after the pressure sequence
of the 2nd Transfer Roller has been started.

Xerox Phaser 6120 Specifications

General

Color	Yes
Print technology	Laser
Time to first page (black, normal)	13 s
Time to first page (color, normal)	22 s
Print speed (black, normal quality, A4/US Letter)	20 ppm
Print speed (color, normal quality, A4/US Letter)	5 ppm
Internal memory	128 MB
Processor model	300 MHz, 32 bit RISC
Maximum print size	210 x 297 mm
Maximum ISO A-series paper size	A4
I/O ports	USB
Power requirements	200 – 240 VAC / 100 – 127 VAC 50/60 Hz
Networking features	Ethernet/Fast-Ethernet
Non-operating relative humidity (non-condensing)	10 - 85 %
Total input capacity	200 sheets
Maximum input capacity	500 sheets
Printer fonts	PostScript
Maximum duty cycle	35000 pages per month
Number of PostScript fonts	139
Power consumption (printing)	380 W
Storage temperature (T-T)	-20 - 40 °C
Operating temperature (T-T)	10 - 32 °C
Operating relative humidity (H-H)	10 - 80 %

Weight and Dimensions

Dimensions (WxDxH)	442 x 395 x 341 mm