EasyManuals Logo
Home>Xerox>Printer>Phaser 6120

Xerox Phaser 6120 Service Manual

Xerox Phaser 6120
366 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #91 background imageLoading...
Page #91 background image
Overview
Phaser® 6120 Color Laser Printer Service Manual
4-3
Paper Path Test
Run the Paper Path diagnostic test to confirm the functionality of all electro-mechanical
components (rollers, clutches, motors, sensors, etc.) required by the printer to successfully
pick and feed paper through the printer.
Note: This test will not run if the printer is currently in an error state.
Test Notes:
1. The test will run continuously until the paper tray is empty.
2. The Control Panel is blank during this test.
3. No image is placed on the paper during the test.
Use the procedure below to initiate the Paper Path Diagnostic test:
1. Power off the printer.
2. Remove the PWB-P (Image Processor Board) form the printer. Refer to page XX for
PWB-P removal procedures.
3. Load enough paper in either paper tray to adequately test the printer.
4. Power up the printer to initiate the test.
Test Results:
Observe the behavior of the printer while running this test. If the printer stalls, focus the
troubleshooting efforts on the immediate area within the printer where the paper stopped. It
may be required to run the test multiple times to isolate the exact problem area.

Table of Contents

Other manuals for Xerox Phaser 6120

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xerox Phaser 6120 and is the answer not in the manual?

Xerox Phaser 6120 Specifications

General IconGeneral
ColorYes
Print technologyLaser
Time to first page (black, normal)13 s
Time to first page (color, normal)22 s
Print speed (black, normal quality, A4/US Letter)20 ppm
Print speed (color, normal quality, A4/US Letter)5 ppm
Internal memory128 MB
Processor model300 MHz, 32 bit RISC
Maximum print size210 x 297 mm
Maximum ISO A-series paper sizeA4
I/O portsUSB
Power requirements200 – 240 VAC / 100 – 127 VAC 50/60 Hz
Networking featuresEthernet/Fast-Ethernet
Non-operating relative humidity (non-condensing)10 - 85 %
Total input capacity200 sheets
Maximum input capacity500 sheets
Printer fontsPostScript
Maximum duty cycle35000 pages per month
Number of PostScript fonts139
Power consumption (printing)380 W
Storage temperature (T-T)-20 - 40 °C
Operating temperature (T-T)10 - 32 °C
Operating relative humidity (H-H)10 - 80 %
Weight and Dimensions IconWeight and Dimensions
Dimensions (WxDxH)442 x 395 x 341 mm

Related product manuals