Xerox Phaser 6120 Service Manual

Maintenance Procedures
Phaser® 6120 Color Laser Printer Service Manual
2-13
4. Remove the Transfer Belt [3].
Caution: When replacing the Transfer Belt, use care not to touch the surface of the belt.
A scratchy or dirty belt could result in image problems. Do not over-tighten the coin
screws because you may strip the plastic threads.
5. To reinstall, reverse the order of removal.
6. When the Transfer Belt is replaced with a new one, it is necessary to reset the life counter
in the Service menu, see Entering the Service Menu on page 30.
7. Perform the Density Calibration in the Quality menu. For information about the density
control, see DENSITY CALIBRATION on page 3-18.
[3]
4139fs2004c0

Xerox Phaser 6120 Specifications

General

Color	Yes
Print technology	Laser
Time to first page (black, normal)	13 s
Time to first page (color, normal)	22 s
Print speed (black, normal quality, A4/US Letter)	20 ppm
Print speed (color, normal quality, A4/US Letter)	5 ppm
Internal memory	128 MB
Processor model	300 MHz, 32 bit RISC
Maximum print size	210 x 297 mm
Maximum ISO A-series paper size	A4
I/O ports	USB
Power requirements	200 – 240 VAC / 100 – 127 VAC 50/60 Hz
Networking features	Ethernet/Fast-Ethernet
Non-operating relative humidity (non-condensing)	10 - 85 %
Total input capacity	200 sheets
Maximum input capacity	500 sheets
Printer fonts	PostScript
Maximum duty cycle	35000 pages per month
Number of PostScript fonts	139
Power consumption (printing)	380 W
Storage temperature (T-T)	-20 - 40 °C
Operating temperature (T-T)	10 - 32 °C
Operating relative humidity (H-H)	10 - 80 %

Weight and Dimensions

Dimensions (WxDxH)	442 x 395 x 341 mm