Xerox Phaser 6120 Service Manual

Phaser® 6120 Color Laser Printer Service Manual
3-17
DUPLEX
ORIENTATION
JAM RECOVERY
Function Selects whether or not the duplex print function is used.
Use To use the duplex print function.
OFF: Duplex printing is not possible.
LONG EDGE: The pages will be printed on both sides of the paper for long-
edge binding.
SHORT EDGE: The pages will be printed on both sides of the paper for
short-edge binding.
Setting/procedure The default setting is OFF.
“OFF”, LONG EDGE, SHORT EDGE
This setting is available only when a Duplex Unit is installed.
Function Specifies the orientation of the media.
Use To change the orientation of the media.
Setting/procedure The default setting is PORTRAIT.
“PORTRAIT”, LANDSCAPE
Function Selects whether or not the page is printed again after recovering from a
media misfeed.
Use To specify the point from which printing should continue after a media
misfeed.
ON: The page that was misfeed is printed again.
OFF: Printing continues with the next page without reprinting the misfed
page.
Setting/procedure The default setting is ON.
“ON”, OFF

Xerox Phaser 6120 Specifications

General

Color	Yes
Print technology	Laser
Time to first page (black, normal)	13 s
Time to first page (color, normal)	22 s
Print speed (black, normal quality, A4/US Letter)	20 ppm
Print speed (color, normal quality, A4/US Letter)	5 ppm
Internal memory	128 MB
Processor model	300 MHz, 32 bit RISC
Maximum print size	210 x 297 mm
Maximum ISO A-series paper size	A4
I/O ports	USB
Power requirements	200 – 240 VAC / 100 – 127 VAC 50/60 Hz
Networking features	Ethernet/Fast-Ethernet
Non-operating relative humidity (non-condensing)	10 - 85 %
Total input capacity	200 sheets
Maximum input capacity	500 sheets
Printer fonts	PostScript
Maximum duty cycle	35000 pages per month
Number of PostScript fonts	139
Power consumption (printing)	380 W
Storage temperature (T-T)	-20 - 40 °C
Operating temperature (T-T)	10 - 32 °C
Operating relative humidity (H-H)	10 - 80 %

Weight and Dimensions

Dimensions (WxDxH)	442 x 395 x 341 mm