3-180 Phaser 7400 Color Printer Service Manual
Waste Cartridge is Almost Full
The Waste Toner Reservoir Full Sensor signal connects to HVPS connector CN4, and
then from the HVPS connector CN1 through a ribbon cable to the Engine Control
Board HVOLT connector. The Waste Toner Reservoir Full Sensor is a Hall-Effect
sensor. Test this type of sensor by placing a strong magnetic source near the sensor.
Initial Actions:
■ Cycle the printer's power.
■ If the problem persists follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack References
■ Waste Toner Reservoir Full Sensor ■ Print Engine Map 1 (page 10-4)
■ Print Engine HVPS (page 10-38)
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1
Check the following for evidence of fault,
debris, or damage:
■ Waste Toner Reservoir Full
Sensor and harness
■ HVPS
■ HVOLT Harness
Replace any
damaged parts.
Go to Step 2.
2
Check the Waste Toner Reservoir Full
Sensor harness for continuity.
Is the harness conductive?
Go to Step 3. Replace the
harness.
3
Replace the Waste Toner Reservoir Full
Sensor.
Does the error persist?
Replace the Engine
Control Board
(
page 8-112).
Complete