8-148 Phaser 7400 Color Printer Service Manual
Registration Sensor Board
The Registration Sensor Board includes the Front Color Registration Sensor attached
by a ribbon cable, the Rear Color Registration Sensor integrated onto the board, the
interface for the ADC Sensor, and the Transfer Unit Belt Slack Sensor. Replacement
of either Color Registration Sensor requires replacement of the board.
Note
The Color Registration Sensors are protected from the Transfer Unit belt by
small, transparent covers. These covers are held in place by a hook and the
presence of the sensor. Use care not to loose these sensor covers.
1. Remove the Registration Sensor Assembly (page 8-80).
2. Turn the assembly over and remove the 2 (metal, 6 mm) screws that secure both
parts of the board.
3. Remove the Registration Shutter Solenoid (page 8-81).
4. Disconnect the connectors on the Registration Sensor Board.
5. Slide the ribbon cable connected to the Front Color Registration Sensor out from
under the retainers and remove the board.
s7400-69
Registration Sensor Board
Connecting Cable