Xerox Phaser 7760 Service Manual

January 2010
xxi
Phaser 7760 Color Laser Printer
Specifications
Introduction
Revised
Mounting Surface Specifications
These specifications apply to any Phaser 7760 printer used as a table-top printer, without a
lower tray assembly or cart. There are 4 feet on the bottom of the printer. The right hand side of
the printer is more susceptible to problems due to foot placement.
1. In order to function properly, the printer must be located on a surface with the following
minimum dimensions (Figure 3). All 4 feet must rest squarely on the mounting surface.
Figure 3 Mounting Surface Dimensions
2. Mounting surface flatness must be within the range shown in Figure 4.
Figure 4 Mounting Surface Flatness
3. The printer must not be tipped or tilted more than 5 mm as in Figure 5.
Figure 5 Maximum Dimension for Tilting or Tipting
Failure to adhere to these mounting specifications will void all guarantees of print-quality
and/or performance. Known problems that can occur as a result of exceeding the mount-
ing surface specifications are:
• Color-to-Color mis-registration, primarily in the horizontal (laser scan) direction.
• A smear or line of toner approximately 40 mm from the trailing edge of the print.

Xerox Phaser 7760 Specifications

General

Brand	Xerox
Model	Phaser 7760
Category	Printer
Language	English