Xerox Phaser 7760 Service Manual

January 2010
4-49
Phaser 7760 Color Laser Printer
REP 9.18
Repairs and Adjustments
Revised
REP 9.18 IBT Cam Lever
Parts List on PL 5.1
Removal
1. Open the Front Cover.
2. Remove the Fuser Cover (REP 14.8).
3. Remove the Waste Toner Cartridge.
4. Remove the Waste Toner Cartridge Cover (REP 9.3).
5. Remove the Inner Cover (REP 14.10).
6. Remove the Imaging Units.
7. Remove the Right Cover (REP 14.3).
8. Remove the IBT Belt Assembly (REP 9.15).
9. Removing the Lever Assembly (Figure 1).
a. On the left-hand side, remove 1 screw, 1 Washer, and 1 Hinge Pin.
b. On the right-hand side, remove 1 E-Ring and 1 Hinge Pin.
c. Remove the IBT Cam Level.
Figure 1 Removing Lever Assembly
Replacement
NOTE: Ensure the Right and Left Lift Assemblies are fully extended.
1. Move the Lever to down position before reinstalling the IBT Belt Assembly.
2. Slide the Main Level Gears under the Lift Jack Assembly Racks and lift into position. Ver-
ify that the Timing Marks on the IBT Cam Lever and the Lift Jack Assemblies align (Figure
2). The IBT Cam Lever Assembly requires extra pressure approximately 1” from the front
of the Printer when properly aligned.
Figure 2 Index Marks

Xerox Phaser 7760 Specifications

General

Brand	Xerox
Model	Phaser 7760
Category	Printer
Language	English