Copy WorkCentre
®
5945/5955
126 User Guide
14. Press the Start button on the control panel to scan the original.
15. Remove the first segment originals after they have been scanned. The Build Job screen displays
the first segment in the list.
16. If required, select the options for the segment.
• Sample Last Segment produces a proof print of the last segment scanned. If you are
satisfied with the proof you can continue programming the Build Job.
• Delete Last Segment deletes the last segment scanned. You can continue programming
the Build Job.
• Delete All Segments deletes the current Build Job and returns you to the main Build Job
screen.
17. Select the features required for the second segment.
18. Load the second segment originals.
19. Press the Start button on the control panel to scan the original.
20. Repeat these steps until all segments of your job have been programmed and scanned.
21. Enter the number of prints required using the numeric keypad on the control panel.
22. After the last segment has been scanned, select the Submit Job button.
23. Press the Job Status button on the device control panel to view the job list and check the status
of the job.
24. If your job remains held in the Active Jobs list, the device needs you to supply additional
resources, such as paper or staples before it can complete the job. To find out what resources
are needed, select the job and then select the Details button. Once the resources are available
the job will print.
More Information
Printing a Sample of Build Job Copy Set
Using a User ID to Log In at the Device
Viewing the Progress and Details of a Job using the Job Status Menu
Printing a Sample of Build Job Copy Set
When you press the Start button to make a copy, the device scans your originals and temporarily
stores the images. It then prints the images based on the selections made.
If Authentication or Accounting has been enabled on your device you may have to enter login
details to access the Copy features.
When copying a large number of sets, use the Sample Job feature to review a proof copy to ensure
that all the print settings are correct before printing the remaining sets.
1. Load your documents face up in the document feeder input tray. Adjust the guide to just touch
the documents.
Or
Lift up the document feeder. Place the document face down onto the document glass and
register it to the arrow at the top left corner. Close the document feeder.
2. Press the Clear All button on the control panel to cancel any previous programming selections.
3. Press the Services Home button.
4. Select the Copy button on the touch screen. The copy features are displayed.
To Next Page
Loading...
Need help?
General
