General Procedures and Information
6-52 11/05 Workcentre PE 220
GP 9 General Precautions on Disassembly
When you disassemble and reassemble components, you must use extreme caution. The close
proximity of cables
to moving parts makes proper routing a must.
If components are removed, any cables disturbed by the procedure must be restored as close as
possible to their
original positions. Before removing any component from the machine, note the cable routing that
will be affected.
Whenever servicing the machine, you must perform as follows:
1. Check to verify that documents are not stored in memory.
2. Be sure to remove the print cartridge before you disassemble parts.
3. Unplug the power cord.
4. Use a flat and clean surface.
5. Replace only with authorized compnents.
6. Do not force plastic-material components.
7. Make sure all components are in their proper position.
8. Run a settings report if possible to restore customer settings at the end of the service call.
Releasing Plastic Latches
Many of the parts are held in place with plastic latches. The latches break easily; release them
carefully.
To remove such parts, press the hook end of the latch away from the part to which it is latched.
Figure 1
To Next Page
Loading...
Need help?
General
