Image Quality
Workcentre PE 220 11/05 3-11
IQ 9 Ghost (1)
Description
Ghost occurs at 75.5 mm intervals of the OPC drum on the print.
IQ 10 Ghost (2)
Description
Ghost occurs at 75.5 mm intervals of the OPC drum on the print.
(When printing on card stock or transparencies using manual feeder)
Check and Cause Solution
1. Bad contacts caused by contamina-
tion from toner particles between high
voltage terminal in the main body and
the electrode of the Developer.
1. Clean the terminals.
2. The life of developer is expired. 2. Install a new print cartridge, PL 1
.
3. Transfer roller lifetime (50.000
sheets) has expired.
3. Check the transfer roller lifetime
and if necessary install a new trans-
fer roller, PL 6
.
4. Abnormal low temperature (below
10°C).
4. Wait about 30 minutes after
power on before using the machine.
5. Bad contacts caused by contamina-
tion from toner particles between high
voltage terminal in the main body and
the one in the HVPS board.
5. Install a new main PBA or
HVPS, PL 1
.
Check and Cause Solution
When printing on card stock thicker
than normal paper or transparen-
cies such as OHP, higher transfer
voltage is required.
Inform the customer to Select 'Thick
Mode' on paper type menu from the
software application and after using
returning to the original mode is
recommended.
To Next Page
Loading...
Need help?
General
