ZCU102 Evaluation Board User Guide www.xilinx.com 105
UG1182 (v1.2) March 20, 2017
Chapter 3: Board Component Descriptions
The system controller user interface allows the FMC IPMI routine to be overridden and an
explicit value can be set for the VADJ_FMC rail. Override mode is useful for FMC mezzanine
cards that do not contain valid IPMI EPROM data defined by the ANSI/VITA57.1
specification.
TI MSP430 System Controller
[Figure 2-1, callout 18]
The ZCU102 board includes an on-board MSP430 with integrated Power Advantage demo
and System Controller firmware. A Host PC resident system controller user interface (SCUI)
is provided on the ZCU102 web page
. This GUI enables you to query and control select
programmable features such as clocks, FMC functionality, power systems, and the Zynq
UltraScale+ MPSoC GTR selection compatible with your design. The ZCU102 web page also
includes a tutorial on the SCUI (XTP433) [Ref 11] and board setup instructions (XTP435)
[Ref 12]. The following briefly summarizes these instructions:
1. Ensure that the Silicon Labs VCP USB-UART drivers are installed.
2. Download the SCUI Host PC application.
3. Connect the micro-USB to ZCU102 USB-UART connector (J83).
4. Power-cycle the ZCU102.
5. Observe that SYSCTLR LED0 (DS47) blinks and LED1 DS46 is illuminated.
6. Launch the SCUI.
The SCUI GUI is shown in Figure 3-40.
To Next Page
Loading...
Need help?
General
