29
When the inverter is in the stopping state, it will running a c cording to jog frequency (refer to P3.06~P3.08 for details)
after receiving jog running command (e.g after pressing key)
1
1
1
1 ： Close
Close
Close
Close loop
loop
loop
loop
If the close loop running function is enabled (P7.00=1), the inverter will enter the close loop running modes, that is, it
will perform PI adjust according to the reference and feedback value (refer to parameters in g roup P7
),
PI adjuster
ou t put is the ess en tial command of inverter
’
s output frequency. Close loop running can be disabled
by
multi-function
terminal (No.27 function) and the inverter will be in a running mode with low er priority.
2
2
2
2 ： PLC
PLC
PLC
PLC running
running
running
running
If PLC function is enabled ( Unit
’
s place of P8.00 is set to a non-zero value), the inverter will enter PLC running mode
and running in the pre-defined running mode (refer to parameter description in group P8 ). PLC running can be
disabled
by
multi-function terminal (No.29 funcition) and the inverter will select a running mode with low priority.
3
3
3
3 ： Multi-speed
Multi-speed
Multi-speed
Multi-speed running
running
running
running
Select Multi-frequency 1~7 (P3.26 ～ P3.32) to realize multi-speed running
by
no-zero combination of multi-function
terminal (No.1, 2 and 3 function s )
4
4
4
4 ： Common
Common
Common
Common running
running
running
running
Common running is actually the open loop running mode.
Fig.
Fig.
Fig.
Fig. 3-1
3-1
3-1
3-1 Running
Running
Running
Running state
state
state
state of
of
of
of V5
V5
V5
V5
Except “ Jog running ”
,
other 4 kinds running modes can be enabled
by
multi-frequency setting method. Besides, “ PLC
running ”
,
“ multi-speed running ”
,
“ common running ” can be used as traverse frequency.
3-2.
3-2.
3-2.
3-2. Use
Use
Use
Use the
the
the
the keyboard
keyboard
keyboard
keyboard
3-2-1.
3-2-1.
3-2-1.
3-2-1. K
K
K
K eyboard
eyboard
eyboard
eyboard layout
layout
layout
layout
Start, speed, stop, brake, running parameter setting and control of the peripheral can be performed
by
inverter
’
s operation
To Next Page
Loading...
Need help?
General
