Digital Operator Functions
6-105
Energy Monitor Initialize (o2-14)
This function can be used to initialize the energy monitor by setting parameter o2-14 to 1.
HAND Key Funktion Selection (o2-15)
With this parameter the HAND key can be disabled by setting parameter o2-15 to 0. The factory setting is 1,
HAND key enabled.
Copying Constants
The Digital Operator can perform the following three functions using a built-in EEPROM (non-volatile mem-
ory).
• Store Inverter constant set values in the Digital Operator (READ)
• Write constant set values stored in the Digital Operator to the Inverter (COPY)
• Compare constant set values stored in the Digital Operator with Inverter constants settings (VERIFY)
Related Constants
Con-
stant
Number
Name Description
Setting
Range
Factory
Setting
Change
during
Opera-
tion
Access
Level
o3-01 Copy function selection
0: Normal operation
1: READ (Inverter to Operator)
2: COPY (Operator to Inverter)
3: Verify (compare)
0 to 3 0 No A
o3-02 Read permitted selection
0: READ prohibited
1: READ permitted
0 or 1 0 No A
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General