4 - 24 TC70x/TC75x Integrator Guide
• Engine Decode LED - Use to turn on scanner red LED when the scan beam is emitting either by scanner
trigger or using soft scan button (RS507 only).
• BT Disconnect On Exit - Bluetooth connection is disconnected when data capture application is closed
(RS507 and RS6000 only).
• Connection Idle Time - Set connection idle time. The Bluetooth connection disconnects after being idle for
set time (RS507 and RS6000 only).
• Decode Haptic Feedback - Enable the device to vibrate upon a good decode (default - enabled).
• Display BT Address Barcode - Enable or disable displaying Bluetooth Address bar code if there is no
Bluetooth scanner being paired when application tries to enable the Bluetooth scanner (RS507 and RS6000
only).
• Establish Connection Time - The timeout which the device will try to enable or reconnect to the Bluetooth
scanner when the Bluetooth scanner is not in the vicinity or not paired (RS507 and RS6000 only).
• Audio Feedback Mode - Select good decode audio indication (RS507 and RS6000 only).
• Local Audio Feedback - Good decode audio indication on TC70x/TC75x only.
• Remote Audio Feedback - Good decode audio indication on Bluetooth scanner only.
•Both - Good decode audio indication on TC70x/TC75x and Bluetooth scanner.
• Disable - No good decode audio indication on either TC70x/TC75x or Bluetooth scanner (default).
• LED Feedback Mode - Select good decode LED indication (RS507 and RS6000 only).
• Local LED Feedback - Good decode LED indication on TC70x/TC75x only.
• Remote LED Feedback - Good decode LED indication on Bluetooth scanner only.
•Both - Good decode LED indication on TC70x/TC75x and Bluetooth scanner (default).
• Disable - No good decode LED indication on either TC70x/TC75x or Bluetooth scanner.
• Decode Audio Feedback - Select an audio tone to sound upon a good decode.
• Decoding LED Notification - Enable the device to light the red Data Capture LED when data capture is in
progress. (default - disabled).
• Decode Feedback LED Timer - Set the amount of time (in milliseconds) that the green Data Capture LED
stays lit after a good decode. (default - 75 msec.)
• Beep Volume Channel - Set the good decode beep to a system or other sound. This allows for independent
control of the good beep volume.
•Media - Set the good decode beep to the media sound.
• Ringer - Set the good decode beep to the ringer sound.
• Notifications - Set the good decode beep to the notification sound (default).
• Alarms - Set the good decode beep to the alarm sound.
Keystroke Output
Use to configure the Keystroke Output Plug-in for the profile.
• Enabled — Enables or disables this plug-in. A check in the checkbox indicates that the plug-in is enabled
(default - enabled).
NOTE Not all ringtones are fully supported as decode tones and those of longer length may be truncated when
used as a decode tone. The recommendation is to test the selected tone for operation before deployment
to a customer site.
To Next Page
Loading...
Need help?
General
