Zebra TC700K User Manual

DataWedge 4 - 33
Defining Criteria
1. Touch Criteria.
Figure 4-22 Criteria Screen
2. Touch String to check for option to specify the string that must be present in the data.
3. In the Enter the string to check for dialog box, enter the string.
4. Touch OK.
5. Touch String position option to specify the position of the string specified in the String to check for option.
The ADF rule is only applied if the specific string in String to check for is found at the specified String
position location (zero for the start of the string).
6. Touch the + or - to change the value.
7. Touch OK.
8. Touch String length option to specify a length for the received data. The ADF rule only applies to the bar code
data with that specified length.
9. Touch the + or - to change the value.
10. Touch OK.
11. Touch Source criteria option to associate an input device to an ADF rule. The ADF rule only applies to data
received from associated input devices.
12. Touch Barcode input. Options vary depending upon the device configuration.
13. Touch the Source enabled checkbox to accept data from this source.

Zebra TC700K Specifications

General

Brand	Zebra
Model	TC700K
Category	Handhelds
Language	English