Danger!
The elevator machine has cast-on eyelets or threads for attachment of eye bolts. The eyelets are
only designed to transport the elevator machine including break and driving disk. Do not lift other
loads such as bolted on bases, machine frames, ropes lying on top, etc. with the eyelets. Suitable
lifting gear must be used.
Warning!
Depending on the operating conditions, the elevator machine can have considerable surface
temperatures > 80°C.
Risk of burns!
If the installation situation does not provide sufficient personal protection, then this must be
provided by the customer in the form of additional measures.
If work has to be carried out on the elevator machine at normal operating temperature, then
you must wear suitable gloves.
Warning!
Warning of hand injuries!
Risk of injury from reaching into the rope guard.
Do not carry out any activities during operation.
Only perform maintenance work on the drive when stopped.
The elevator machine is only to be operated within the ranges dened on the motor type plate!
Use the machine only in the authorised fashion and only for the tasks and flow media specified in
the order!
If the elevator machine is not energised, no electric torque is available. Releasing the brakes can
cause uncontrolled acceleration of the elevator.
We recommend short-circuiting the windings of the de-energised elevator machine to generate a
brake torque dependent on the speed.
In the event of a short-circuit, a short-circuit current of at least the level of the rated current is
flowing.
The windings may not be short-circuited when the elevator machine is energised.
Safety features, for example the brake release monitoring, may not be dismantled, circumvented or
made inoperative!
Thermistor installed in the winding act as protection against excess temperatures in the elevator
machine and must be evaluated. When the thermistor are activated, the energy supply to the
elevator machine must be switched off.
2.7 Operator’s obligation of diligence
The elevator machine has been designed and built after consideration of a risk analysis and after
careful selection of the harmonised standards to be complied with as well as other technical specifica-
tions. It therefore complies with the state of the art and guarantees maximum safety during operation.
However, this safety can only be achieved in practical operation when all the necessary measures are
taken. The machine operator therefore has a duty of care to ensure that these measures are planned
and to supervise their execution.
In particular, the operator must ensure that
the elevator machine is used as intended (see chapter “Product overview”)
the installation is operated in a flawless, functional condition and the safety devices are periodically
checked for their properly functioning condition
The required personal safety gear is available to and used by the operating, maintenance and
repair personnel
Translation of the original operating instructions
ZAtop – model series SM210.60B/SM210.70B Safety instructions
$7%$B*% ,QGH[ Part.-No. 01013389-GB (EU-BD 1014)
7/88
To Next Page
Loading...
Need help?
General
